Get a Recommendation
Tell us the floor. We'll specify the machine.
Tell us about the site and what you need cleaning. We’ll recommend the machines worth considering.
TRUSTED BY:
The surface that fights back
Concrete is the most common industrial floor and the most demanding one to keep clean. Untreated and power-floated slabs shed fine dust continuously — the "dusting" that settles on racking and stock within hours of sweeping — and the surface is abrasive enough to wear brushes and squeegee blades noticeably faster than a coated or tiled floor.
That changes the specification rather than the machine. Bristle grade has to suit an open, abrasive surface, and on a scrubber-dryer the squeegee rubber has to hold its edge against it — get either wrong and you get streaking, poor pick-up and a consumables bill that arrives twice as often as it should.
Sequence matters too. On a dusting slab, sweeping first and scrubbing second is what actually works: a scrubber-dryer sent over loose concrete dust turns it to slurry and drags it around. Where the floor is sealed, a scrubber-dryer alone usually holds it.
We match the brush and blade grades to the slab, not just to the machine — and we supply the replacement brushes and blades afterwards, so the running cost is known before you buy.
Showing 7 machines suited to this environment
01 How do I stop a concrete floor dusting?
Cleaning manages it; sealing cures it. A sweeper with an intact filter lifts the dust into the hopper instead of redistributing it, which a broom cannot do and which is the single biggest improvement on most bare slabs. If the slab is breaking down badly, sealing it is the long-term answer and the machine then keeps it that way.
02 Sweeper or scrubber-dryer for concrete?
Bare or dusting concrete wants a sweeper first — dry debris and dust into a hopper. Sealed or power-floated concrete that needs to look clean as well as be clear wants a scrubber-dryer. On a dusting floor that needs both, sweep first and scrub second; a scrubber-dryer run over loose dust just makes slurry.
03 Why do brushes and blades wear out so fast on concrete?
Because the surface is abrasive, and usually because the grade was chosen for the machine rather than the floor. Bristle grade and squeegee rubber both need specifying for an open concrete surface. Getting that right is the difference between replacing consumables on a sensible cycle and replacing them constantly.
04 Will a machine remove tyre marks and ground-in dirt?
A scrubber-dryer will, given the right brush pressure and pad grade — that is scrubbing work, not sweeping. Tell us what is marking the floor and how long it has been there; on a neglected slab the first pass is a recovery clean and the routine afterwards is much lighter.
05 Can I try one on our floor before buying?
Concrete is exactly the floor where that is worth doing, because slabs vary so much. Hire the machine for a few weeks and run it on your own surface — it settles the brush and blade specification as well as the machine choice.
